Shopping Cart

Log in / Register

Jaguar and Land Rover Service Hand Held

Jaguar and Land Rover Service Hand Held
Only £595.00 + VAT
SORRY
Currently Unavailable
P/No. : dast512

Jaguar and Land Rover Service Hand Held

Overview

  • Jaguar & Land Rover approved device
  • Operates standalone with special applications. E.g. SIR, EPBR DPFDR, etc.
  • Also allows connection to the vehicle using JLR SDD diagnostic software via J2534
  • Covers CAN, ISO9141, SCP vehicle networks
  • 1metre USB Cable included as standard
  • Free to update for new vehicles and model years via laptop/PC application over USB

The DA-ST512 connects directly to the vehicle OBDII diagnostic connector, powers from the vehicle and is then ready to use.

The DA-ST512 can perform a vast number of applications, a selection of which is provided below.

The DA-ST512 can also be used as a SDD J2534 VCI device where connects directly to the vehicle OBDII diagnostic connector, it then connects to the laptop via a USB cable for use with SDD. Once the J2534 DLL files are loaded, this product will allow normal operation with JLR SDD diagnostic software. All protocol communication are possible with this device.

Read & Clear Fault Codes

This application Reads all the DTCs from all the ECUs on the High Speed CAN bus, Low Speed CAN bus and MOST ECU connected via the diagnostic Gateway. DTCs can be & Clear cleared globally or ECUs individually.

SIR – Service Reset

This application resets the service light and/or oil change reset depending on Interval Reset the vehicle. Note some vehicles have a manual procedure for this function.

EPBR – Electronic Park Brake Release

Moves the electronic park brake to the mount position and then releases the Park Brake Release brake callipers.

J2534 - VCI Gateway mode

Once the JLR J2534 DLL files are loaded, this product will allow normal operation Gateway mode with JLR SDD Diagnostic software (subscription required). All protocol communication is possible with this device.

TTMT – Tight Tolerance Mode Toggle

Toggles between tight tolerance mode and customer mode on the vehicle to Tolerance Mode allowing steering or chassis alignments.

DPFDR – DPF Dynamic Regeneration

The DPFDR application allows the vehicles DPF dynamic regeneration process Dynamic to be undertaken to clear the DPF of soot build up.

DPFAR – DPF Adaption Reset

The DPFAR application resets the DPF soot value enabling the DPF dynamic Adaption Reset regeneration to be performed or following the fitment of a new diesel particulate filter.

Downloads

Product Information Sheet

User Manual

DA App Hub Setup

The DA App Hub is a PC based application that is installed to allow you to check for software updates with release information for your DA-Dongle and DA-VINA 2534 products and trial applications if you have a DA-ST512 device.

The DA App Hub supercedes the DA Software Update Tool that your user's manual may refer to. For the latest version of your device user's manual please see the DA Product User's Manual section below.

The PC that this application is installed on needs to be connected to the internet to allow software updates to be downloaded automatically to your DA device.

Please Note : After installation of the DA App Hub you need to connect your DA device to your PC via the USB cable BEFORE you run the DA App Hub for the first time. This is necessary to complete the device driver installation.

DAA App Setup