Shopping Cart

Log in / Register

Jaguar and Land Rover Service Interval Reset

Jaguar and Land Rover Service Interval Reset
Only £199.00 + VAT
Currently Unavailable
P/No. : dasir

Jaguar and Land Rover Service Interval Reset

The DA-Dongle connects directly to the vehicle OBDII (diagnostic) connector and is a stand-alone product that requires no other cables during operation. The device does not need to be used with IDS/SDD.

Once connected to the OBDII connector it will perform the Service Interval Reset via diagnostic communication to the Instrument Cluster module. This will remove the service warning from the Instrument Cluster and reset the counter in preparation for the next service interval.

How does the DA-Dongle operate the SIR process?

The DA-Dongle SIR device is simple and easy to use

  • Connect the SIR device to the vehicle OBDII connector (the device powers from the vehicle)
  • The device enters trigger mode – flashing red/green status (STS) LED
  • The trigger is for the operator to switch on the vehicle ignition
  • The application begins to run, this is shown by a green flashing status (STS) LED
  • Once complete the status (STS) LED turns solid green and the device omits a constant high-pitched audible tone to ensure the operator removes the device from the vehicle
  • The task complete approximately within 10 Seconds

How does the DA-Dongle get updated for future Model Years and New Vehicles?

The DA-Dongle can be updated simply and easily by connecting the DA-Dongle to a laptop/PC via the USB cable that is provided with each DA-Dongle.

A PC software update application is available to download below. This application once downloaded and launched will be responsible for identifying what version of software is on the device, and whether a new version is available for update.

By connecting the device to the PC when the software update application is running, the application will read the device and connect over the internet to determine if an updated software is available and download this to the device if a newer version exists. This process takes approximately 3 minutes to complete. The device will then be updated and ready to be used on the vehicle.

Jaguar and Land Rover Service Interval Reset


SIR Users Manual

DA Software Update Tool

The DA Software Update Tool is a PC based application that is installed to allow you to check for software updates to your DA Dongle and DA-VINA 2534 devices. The PC that this application is installed on needs to be connected to the internet to allow software updates to be downloaded automatically to your DA device.

DA Software Update Tool

Please Note

After installation of the DA Software Update Tool you need to connect your DA device to your PC via the USB cable BEFORE you run the DA Software Update Tool for the first time. This is necessary to complete the device driver installation.

System Requirements:

  • Windows XP SP2 & SP3
  • Windows Vista SP1
  • Windows 7