Shopping Cart

Log in / Register

Jaguar and Land Rover DPF Dynamic Regeneration

Jaguar and Land Rover DPF Dynamic Regeneration
Only £199.00 + VAT
QTY :
P/No. : dadpfdr

Jaguar and Land Rover DPF Dynamic Regeneration

Overview 

  • Operates on JLR vehicles
  • Clears the DPF adaptions to allow the vehicle to be driven through its DPF Dynamic Regeneration
  • Saves time and money compared to IDS/SDD
  • Easy to use with simple user interaction
  • Stand-alone operation, no need to use IDS/SDD or a PC
  • Easy to update for new vehicle and model years via PC (PC application and cable included)

The DA-Dongle connects directly to the vehicle OBDII (diagnostic) connector and is a stand-alone product that requires no other cables during operation. The device does not need to be used with IDS/SDD.

Once the DPFDR Dongle is connected to the OBDII connector the DPF will be cleared using one of the two modes of operation below:

Method 1 - DPF Adaptions Reset

  • IGN ON – Engine not running – The Dongle will clear the adaptions to so DPFDR Drive cycle can begin. STS LED will be flashing green then solid green with beep once complete.

Method 2 – DPF Dynamic Regeneration

  • IGN ON – Engine running – The Dongle will begin DPFDR drive cycle similar to IDS/SDD.
  • When the engine is up to temperature (60°C) the dongle will beep for 3 seconds every 10 seconds until the road speed is greater than 40KPH. The dynamic regeneration will then begin.
  • The Dongle will emit a short beep increasing in frequency as the soot mass level drops.
  • When the soot mass falls below 6 grams a constant beep will be heard, and the STS LED will show solid green.
  • It should take approximately 15 minutes to complete (when the vehicle is driven above 40 KPH).

It is recommended that a right angled J1962 extension cable be used to ensure the dongle does not interfere with the vehicle controls. This can be purchased along with DPFDR Dongle.

How does the DA-Dongle get updated for future Model Years and New Vehicles?

The DA-Dongle can be updated simply and easily by connecting the DA-Dongle to a laptop/PC via the USB cable that is provided with each DA-Dongle.

A PC software update application is available to download below. This application once downloaded and launched will be responsible for identifying what version of software is on the device, and whether a new version is available for update.

By connecting the device to the PC when the software update application is running, the application will read the device and connect over the internet to determine if an updated software is available and download this to the device if a newer version exists. This process takes approximately 3 minutes to complete. The device will then be updated and ready to be used on the vehicle.

Jaguar and Land Rover DPF Dynamic Regeneration

Downloads

DPFDR Users Manual

DA Software Update Tool

The DA Software Update Tool is a PC based application that is installed to allow you to check for software updates to your DA Dongle and DA-VINA 2534 devices. The PC that this application is installed on needs to be connected to the internet to allow software updates to be downloaded automatically to your DA device.

DA Software Update Tool

Please Note

After installation of the DA Software Update Tool you need to connect your DA device to your PC via the USB cable BEFORE you run the DA Software Update Tool for the first time. This is necessary to complete the device driver installation.

System Requirements:

  • Windows XP SP2 & SP3
  • Windows Vista SP1
  • Windows 7